ACT Silicone Emblem Stylish Design

ACT Silicone Emblem Stylish Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

When enthusiasts talk about the golden age of German aftermarket wheels, ACT always comes up alongside legends like ATS and Ronal. The brand made its name during the late Eighties with cast aluminum mesh wheels that were lighter and stiffer than most factory options — a real performance edge on the E30 325is or the E28 535i. These 3D domed center cap emblems carry forward that heritage in miniature. The construction starts with a high-resolution print on automotive-grade vinyl, bonded to a rigid yet flexible substrate. Over that goes a thick dome of UV-stabilized polyurethane resin, poured and cured under controlled humidity to prevent micro-bubbles. The result is a lens-like surface that resists scratches from gravel spray, shrugs off rain and road chemicals, and refuses to yellow even after years of sun exposure. Installation could not be simpler: clean your cap face with isopropyl alcohol, peel the backing, align the emblem, and press firmly for half a minute. The bond is strong enough to survive pressure washers and highway speeds without lifting at the edges. Whether you are finishing a period-correct restoration on a classic 3-Series or just refreshing a tired set of ACT mesh wheels you scored at a swap meet, these emblems bring the caps back to showroom condition. Available diameters span 20 mm through 120 mm, and we can produce custom sizes on request.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.