ACT Silicone Sticker Stylish Design

ACT Silicone Sticker Stylish Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

ACT mesh wheels were the quiet choice of serious BMW drivers in the late 1980s — the kind of wheel you bolted on because you had done your homework, not because you followed a trend. Produced in Germany with single-piece cast aluminum construction, they offered stiffness and weight savings that mattered on back roads and race-day track lapping alike. These 3D domed center cap emblems honor that no-nonsense engineering with equally serious build quality. The vinyl substrate carries a full-color reproduction of the ACT crest, printed with solvent-based inks that resist fading far longer than water-based alternatives. Over the print sits a generous dome of optically clear resin — thick enough to create a noticeable three-dimensional look, yet thin enough to fit inside recessed cap wells without fouling. The resin is formulated to handle UV exposure, road salt, brake dust, diesel soot, and repeated jet-wash passes without cracking, peeling, or yellowing. Mounting is a thirty-second job: wipe the cap with a clean cloth, peel the paper backing from the adhesive, position the emblem, and press. The acrylic adhesive grabs on contact and reaches full bond strength within twenty-four hours. Sizes run from 20 mm up to 120 mm in standard increments, and custom diameters are available for unusual cap designs. One emblem is included per order.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.