Alessio Silicone Sticker Stylish Design

Alessio Silicone Sticker Stylish Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

When Alessio closed its doors around 2008, it left behind thousands of wheels still in active service across Europe — and a growing problem for owners who needed replacement center caps. These 3D domed wheel center cap emblems bring that same Italian style down to the finest detail on your wheels. Each emblem is manufactured by printing the Alessio logo in full color at high resolution onto premium automotive-grade vinyl, using solvent-based inks specifically chosen for their long-term outdoor durability and resistance to fading. Over that printed surface, a thick, controlled pour of UV-stabilized polyurethane resin is applied and allowed to self-level into a perfectly smooth, bubble-free dome. The cured dome creates a glass-like surface with genuine three-dimensional depth that makes the logo appear to float beneath a clear lens. That resin layer does far more than look good — it resists scratches from stone chips and road grit, repels water, brake dust, and road salt, blocks ultraviolet radiation to prevent color fading, and remains flexible enough to survive thermal cycling from freezing winters to hot summer asphalt without cracking, peeling, yellowing, or lifting at the edges. The waterproof seal ensures no moisture can reach the printed layer underneath, keeping the emblem looking factory-fresh for years of daily driving and outdoor exposure. The back of each emblem carries a pre-applied layer of industrial-strength acrylic adhesive under a protective paper liner. Peel the liner, position the emblem on a clean cap, press for thirty seconds, and you are finished — no clips, no screws, no alignment jigs, and no waiting overnight before driving. The adhesive holds firm through rain, snow, heat, vibration, and automated car washes. Standard sizes span 20 mm to 120 mm in diameter; custom orders are welcome for anything outside that range. Listed price covers a single emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.