Chrysler Crossfire Sticker Epoxy 3D Gel Stylish Design

Chrysler Crossfire Sticker Epoxy 3D Gel Stylish Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The Crossfire occupies a unique niche in the collector car market: too new to be vintage, too old to be modern, and too unusual to be ignored — which is why clean examples are steadily appreciating in value. These 3D domed wheel center cap emblems bring that same distinctive Crossfire character down to the finest detail on your wheels. Each emblem is manufactured by printing the Chrysler Crossfire logo in full color at high resolution onto premium automotive-grade vinyl, using solvent-based inks specifically chosen for their long-term outdoor durability and resistance to fading. Over that printed surface, a thick, controlled pour of UV-stabilized polyurethane resin is applied and allowed to self-level into a perfectly smooth, bubble-free dome. The cured dome creates a glass-like surface with genuine three-dimensional depth that makes the logo appear to float beneath a clear lens. That resin layer does far more than look good — it resists scratches from stone chips and road grit, repels water, brake dust, and road salt, blocks ultraviolet radiation to prevent color fading, and remains flexible enough to survive thermal cycling from freezing winters to hot summer asphalt without cracking, peeling, yellowing, or lifting at the edges. The waterproof seal ensures no moisture can reach the printed layer underneath, keeping the emblem looking factory-fresh for years of daily driving and outdoor exposure. A pre-applied pressure-sensitive adhesive with a paper peel-away liner makes fitting effortless. Clean the cap with isopropyl alcohol, peel the backing, align the emblem, and press for half a minute. The bond is rated for permanent outdoor use and handles car washes, highway speeds, pressure washers, and temperature extremes in any climate without peeling or degrading. Diameters are available from 20 mm to 120 mm, with custom sizing on request for unusual or vintage cap configurations. Each order includes a single emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.