Citroen Sticker Epoxy 3D Gel Stylish Design

Citroen Sticker Epoxy 3D Gel Stylish Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

Citroën's monocoque construction on the 1934 Traction Avant was so structurally advanced that the car could be driven on three wheels during factory demonstrations — a dramatic proof of its unibody rigidity. These 3D domed wheel center cap emblems bring that same French engineering heritage down to the finest detail on your wheels. Each emblem is manufactured by printing the Citroen logo in full color at high resolution onto premium automotive-grade vinyl, using solvent-based inks specifically chosen for their long-term outdoor durability and resistance to fading. Over that printed surface, a thick, controlled pour of UV-stabilized polyurethane resin is applied and allowed to self-level into a perfectly smooth, bubble-free dome. The cured dome creates a glass-like surface with genuine three-dimensional depth that makes the logo appear to float beneath a clear lens. That resin layer does far more than look good — it resists scratches from stone chips and road grit, repels water, brake dust, and road salt, blocks ultraviolet radiation to prevent color fading, and remains flexible enough to survive thermal cycling from freezing winters to hot summer asphalt without cracking, peeling, yellowing, or lifting at the edges. The waterproof seal ensures no moisture can reach the printed layer underneath, keeping the emblem looking factory-fresh for years of daily driving and outdoor exposure. Mounting takes about thirty seconds: wipe the cap surface with a clean cloth, peel the adhesive backing, position the emblem carefully, and press down firmly. The industrial-grade acrylic adhesive bonds permanently to metal, plastic, and painted surfaces on contact, reaching full cure strength within twenty-four hours. It survives pressure washers, sub-zero winters, and scorching summer parking lots without lifting or degrading. Sizes range from 20 mm to 120 mm, and custom diameters are available for any non-standard cap configuration. One emblem per order.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.