Ferrari Emblem Center Hub Cap Self-Adhesive Stylish Design

Ferrari Emblem Center Hub Cap Self-Adhesive Stylish Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The 488 GTB proved that Ferrari could make a turbocharged V8 feel as responsive as the naturally aspirated engines that came before it. The 3.9-liter twin-turbo unit produced 661 horsepower and featured a flat-plane crankshaft that gave it a high-revving character closer to a racing engine than a typical turbo road car. Its exhaust note climbed from a deep rumble to a shrill scream at the 8,000 RPM redline, and the throttle response — thanks to clever turbo plumbing and a dual-clutch gearbox that shifted in 0.03 seconds — was virtually instant at any engine speed. These 3D domed wheel center cap emblems match that precision engineering. The Ferrari crest is reproduced on premium automotive vinyl at high resolution using fade-resistant solvent inks. A thick dome of UV-stabilized polyurethane resin covers the entire print, forming a scratch-resistant, waterproof, UV-protected surface. The adhesive is an industrial acrylic film. Clean the cap, peel the protective liner, position the emblem, and press for thirty seconds. The bond is permanent — no tools, no clips, no drilling. Sizes from 20 mm to 120 mm. Custom diameters on request. Each order includes one emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.