Ferrari Logo Silicone Badge Self-Adhesive Limited Edition

Ferrari Logo Silicone Badge Self-Adhesive Limited Edition

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The 812 Superfast's engine development required Ferrari to push naturally aspirated technology to its absolute limits. The 6.5-liter V12 uses variable-geometry intake runners that physically change length based on engine speed, optimizing airflow for both low-end torque and high-RPM power. The crankshaft and connecting rods are forged from high-grade steel alloys that can withstand the stresses of revving to 8,500 RPM under full load, and the engine's compression ratio is optimized for 98-octane fuel to extract every joule of energy from each combustion event. These 3D domed wheel center cap emblems honor that relentless pursuit of naturally aspirated perfection. The Ferrari crest is reproduced on premium automotive vinyl at high resolution with fade-resistant solvent inks. A thick dome of UV-stabilized polyurethane resin covers the entire print, forming a crystal-clear, scratch-resistant, waterproof surface. The adhesive is a pre-applied industrial acrylic film. Clean the cap, peel the protective liner, position the emblem, and press for thirty seconds. The bond is permanent — no tools, no clips, no drilling. Sizes from 20 mm to 120 mm. Custom diameters upon request. Each order includes one emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.