Irmsher Wheel Emblems Sleek Style

Irmsher Wheel Emblems Sleek Style

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

Irmscher Automobilbau was founded in 1968 by Günther Irmscher — a master motor mechanic, engineer, and accomplished rally driver — in a small double garage in the Swabian town of Winnenden, near Stuttgart, Germany. What began as a two-man engine-tuning operation grew into one of the most respected automotive tuning and engineering companies in Europe, with a reputation built on decades of factory-level collaboration with Opel and a motorsport pedigree that spans rally stages, touring-car circuits, and endurance events across the continent. These 3D domed wheel center cap emblems carry the Irmscher badge with the precision the brand demands. The construction starts with a high-resolution digital print of the logo on automotive-grade vinyl, reproducing the emblem with pin-sharp accuracy. Over the print sits a thick dome of optically clear polyurethane resin, poured under controlled conditions and cured to a smooth, bubble-free finish. That resin layer forms a physical shield against stone chips, brake dust, road salt, UV radiation, and the abrasive punishment of automatic car washes, keeping the logo crisp and vibrant season after season. The adhesive backing is a pressure-sensitive 3M-grade acrylic film. Peel the protective liner, center the emblem on a clean, dry cap surface, and press firmly for thirty seconds. The bond grabs on contact and reaches full strength within twenty-four hours — no drilling, no clips, no alignment tools. Whether you drive an Irmscher-tuned Astra or a classic Manta 400, these emblems fit any cap recess from 20 mm to 120 mm in diameter. Custom sizes are available on request, and each order includes one emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.