Jeep Sticker Epoxy 3D Gel Premium Quality

Jeep Sticker Epoxy 3D Gel Premium Quality

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The Jeep Wrangler's 2.0-liter turbocharged four-cylinder engine — combined with the 48-volt mild hybrid eTorque system — provides a modern and efficient alternative to the traditional V6 that does not compromise on performance. The turbocharged engine produces 270 horsepower and 295 lb-ft of torque, with the eTorque system using a belt-starter-generator to fill in torque gaps during acceleration, smooth stop-start transitions, and improve fuel efficiency. The four-cylinder engine's lighter weight compared to the V6 also improves the Wrangler's front-to-rear weight distribution, which can benefit handling on the road and balance on off-camber trail sections. The smaller engine bay also provides more room for aftermarket accessories. These 3D domed wheel center cap emblems suit that turbocharged Wrangler powertrain. Each emblem features the Jeep grille reproduced on premium automotive vinyl at high resolution with fade-resistant solvent inks. A thick dome of UV-stabilized polyurethane resin covers the print, forming a crystal-clear, scratch-resistant, waterproof surface. The adhesive is an industrial acrylic film. Clean the cap, peel, position the emblem, and press for thirty seconds. The bond is permanent — no tools, no clips, no drilling. Sizes from 20 mm to 120 mm. Custom diameters upon request. Each order includes one emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.