Pontiac Logo Sticker Refined Design

Pontiac Logo Sticker Refined Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The third-generation Firebird Formula and Trans Am of the 1980s and 1990s — with the Tuned Port Injection 350 and later the LS1 V8 — kept the rear-wheel-drive, V8-powered American sports car alive during an era when most of the industry had given up on performance. The WS6 Ram Air package on the fourth-gen Trans Am delivered 325 horsepower and sub-five-second zero-to-sixty times from a car that cost less than half the price of a Corvette. These 3D domed wheel center cap emblems carry that Pontiac arrowhead with the pride it deserves. The construction starts with a high-resolution digital print of the badge on automotive-grade vinyl, reproducing the iconic logo with pin-sharp accuracy. Over the print sits a thick dome of optically clear polyurethane resin, poured under controlled conditions and cured to a smooth, bubble-free finish. That resin layer forms a physical shield against stone chips, brake dust, road salt, UV radiation, and the abrasive punishment of automatic car washes, keeping the logo crisp and vibrant season after season. The adhesive backing is a pressure-sensitive 3M-grade acrylic film. Peel the protective liner, center the emblem on a clean, dry cap surface, and press firmly for thirty seconds. The bond grabs on contact and reaches full strength within twenty-four hours — no drilling, no clips, no alignment tools. Whether you drive a Firebird Formula or a numbers-matching 1969 Judge, these emblems fit any cap recess from 20 mm to 120 mm in diameter. Custom sizes are available on request, and each order includes one emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.