Pontiac Sticker Epoxy 3D Gel Refined Design

Pontiac Sticker Epoxy 3D Gel Refined Design

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The third-generation Firebird Formula and Trans Am of the 1980s and 1990s — with the Tuned Port Injection 350 and later the LS1 V8 — kept the rear-wheel-drive, V8-powered American sports car alive during an era when most of the industry had given up on performance. The WS6 Ram Air package on the fourth-gen Trans Am delivered 325 horsepower and sub-five-second zero-to-sixty times from a car that cost less than half the price of a Corvette. These 3D domed wheel center cap emblems match the boldness Pontiac was known for. Built on a premium vinyl substrate, each carries a full-color reproduction of the Pontiac badge. A thick application of UV-resistant polyurethane resin forms a smooth, raised dome that catches light and gives the arrowhead a three-dimensional appearance. The cured resin handles stone impacts, brake dust, jet-wash pressure, and years of sun exposure without scratching, peeling, or yellowing. Installation is a thirty-second job. Wipe the cap surface clean, peel the backing from the pressure-sensitive acrylic adhesive, align the emblem, and push down firmly. The bond locks to metal, plastic, and painted surfaces on contact, with no clips, screws, or special tools needed. Whether you drive a G8 GXP or a numbers-matching 1969 Judge, these emblems fit any cap recess from 20 mm to 120 mm in diameter. Custom sizes are available on request, and each order includes one emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.