Porsche Logo Silicone Sticker Self-Adhesive Deluxe Edition

Porsche Logo Silicone Sticker Self-Adhesive Deluxe Edition

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The water-cooled era of the 911 began with the 996 generation in 1997, a move that divided purists but allowed Porsche to achieve higher power outputs, tighter emissions compliance, and the manufacturing efficiencies needed to survive as an independent company. These 3D domed wheel center cap emblems carry that legacy in every detail. Built on a premium vinyl substrate, each emblem carries a full-color, high-resolution reproduction of the Porsche shield — the Stuttgart horse flanked by antlers and state stripes. A thick application of UV-resistant polyurethane resin is poured over the print, forming a smooth, raised dome that catches light and gives the logo a pronounced three-dimensional appearance. The cured resin is engineered to handle stone impacts, brake-dust buildup, jet-wash pressure, road-salt corrosion, and years of direct sun exposure without scratching, peeling, or yellowing. Installation is a thirty-second job. Wipe the cap surface clean, peel the backing from the pressure-sensitive acrylic adhesive, align the emblem, and push down firmly. The bond locks to metal, plastic, and painted surfaces on contact, with no clips, screws, or special tools needed. Full cure takes twenty-four hours. Standard sizes span 20 mm to 120 mm, accommodating everything from a classic 911S to the latest Macan. Custom measurements are available for any cap that falls outside the standard range. Price is per single emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.