Porsche Silicone Sticker Prestige Line

Porsche Silicone Sticker Prestige Line

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The water-cooled era of the 911 began with the 996 generation in 1997, a move that divided purists but allowed Porsche to achieve higher power outputs, tighter emissions compliance, and the manufacturing efficiencies needed to survive as an independent company. These 3D domed wheel center cap emblems carry that legacy in every detail. Each emblem begins as a precision-cut vinyl disc printed at 1,440 dpi with solvent-based inks chosen specifically for outdoor durability. A generous pour of UV-stabilized polyurethane resin is then applied, self-leveling into a flawless dome that adds visual depth and a glass-like three-dimensional effect. Once cured, the resin is hard enough to shrug off gravel spray, chemically stable enough to resist brake-dust corrosion and road-salt exposure, and UV-treated to prevent yellowing even on cars parked outdoors year-round. The waterproof seal is complete — no moisture or contaminant reaches the printed surface beneath. On the back sits a factory-applied layer of industrial acrylic adhesive protected by a peel-away paper liner. Clean the cap with isopropyl alcohol, remove the liner, position the emblem, and press firmly for half a minute. The bond is permanent on metal, plastic, and painted surfaces — no heat gun, no primer, no tools required. Sizes run from 20 mm to 120 mm, covering every Porsche wheel cap from a classic 911S to the latest 992. Custom diameters are produced on request for any non-standard cap.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.