Porsche Silicone Sticker Resin Elite

Porsche Silicone Sticker Resin Elite

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The Porsche 911 GT3 has been the track-day benchmark since the 996 generation, offering a naturally aspirated flat-six engine, a manual gearbox option, and a chassis set up specifically for circuit driving — a car built for enthusiasts who measure their commitment in lap times. These 3D domed wheel center cap emblems carry that legacy in every detail. Each emblem begins as a precision-cut vinyl disc printed at 1,440 dpi with solvent-based inks chosen specifically for outdoor durability. A generous pour of UV-stabilized polyurethane resin is then applied, self-leveling into a flawless dome that adds visual depth and a glass-like three-dimensional effect. Once cured, the resin is hard enough to shrug off gravel spray, chemically stable enough to resist brake-dust corrosion and road-salt exposure, and UV-treated to prevent yellowing even on cars parked outdoors year-round. The waterproof seal is complete — no moisture or contaminant reaches the printed surface beneath. On the back sits a factory-applied layer of industrial acrylic adhesive protected by a peel-away paper liner. Clean the cap with isopropyl alcohol, remove the liner, position the emblem, and press firmly for half a minute. The bond is permanent on metal, plastic, and painted surfaces — no heat gun, no primer, no tools required. Sizes run from 20 mm to 120 mm, covering every Porsche wheel cap from a Boxster Spyder to the latest 992. Custom diameters are produced on request for any non-standard cap.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.