SSR Sticker Epoxy 3D Gel Elite Finish

SSR Sticker Epoxy 3D Gel Elite Finish

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

SSR's Professor series — the SP1, SP3, and SP5 — represents the pinnacle of three-piece wheel engineering. Each wheel is custom-built to order in Japan with the buyer choosing diameter, width, offset, disk type, lip depth, and finish. That level of customization means no two Professor setups are exactly alike, and it makes the SSR center cap a badge of bespoke craftsmanship. These 3D domed wheel center cap emblems match the craftsmanship SSR puts into every spoke. Built on a premium vinyl substrate, each carries a full-color reproduction of the SSR badge. A thick application of UV-resistant polyurethane resin forms a smooth, raised dome that catches light and gives the logo a three-dimensional appearance. The cured resin handles stone impacts, brake dust, jet-wash pressure, and years of sun exposure without scratching, peeling, or yellowing. Installation is a thirty-second job. Wipe the cap surface clean, peel the backing from the pressure-sensitive acrylic adhesive, align the emblem, and push down firmly. The bond locks to metal, plastic, and painted surfaces on contact, with no clips, screws, or special tools needed. Standard sizes span 20 mm to 120 mm, accommodating everything from a fresh set of Professor MS1s to show-spec builds. Custom measurements are available for any cap outside the standard range. Price is per single emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.