Tesla Emblem Badge Self-Adhesive Elite Finish

Tesla Emblem Badge Self-Adhesive Elite Finish

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The Fremont Factory in California — originally a GM-Toyota joint-venture plant — became Tesla's primary assembly facility in 2010. From a factory that was nearly demolished, Tesla built the production line that delivers Model S, Model 3, Model X, and Model Y vehicles, turning an abandoned building into one of the most productive automotive plants in North America. These 3D domed wheel center cap emblems bring that same attention to detail to your caps. A full-color reproduction of the Tesla emblem is printed on premium vinyl using fade-resistant inks rated for years of sunlight. The dome is crystal-clear polyurethane resin cured to a hard, transparent finish — no bubbles, no imperfections. That cured dome resists scratches, blocks water, deflects UV radiation, and handles thermal cycling from winter frost to summer blacktop. The adhesive is an industrial-grade acrylic pressure-sensitive film rated for permanent outdoor bonding. Peel the liner, set the emblem, press for thirty seconds, and the job is complete. Full bond strength develops within twenty-four hours and holds through every condition the car encounters. Standard sizes span 20 mm to 120 mm, accommodating everything from a Model X Plaid to a track-day build. Custom measurements are available for any cap outside the standard range. Price is per single emblem.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.