Vossen Domed Emblem Signature Grade

Vossen Domed Emblem Signature Grade

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

Deep concavity is the design signature that runs through every Vossen wheel, from the entry-level HF series to the custom-forged CV line. That sculpted, dished face catches light and shadow in a way that flat-spoke designs cannot, and it gives any vehicle — sedan, SUV, or supercar — a visual stance that is unmistakably premium. These 3D domed center cap emblems give your Vossen wheels the finishing detail they deserve. The construction starts with a high-resolution digital print of the Vossen logo on automotive-grade vinyl, reproducing the brand mark with pin-sharp accuracy. Over the print sits a thick dome of optically clear polyurethane resin, poured under controlled conditions and cured to a smooth, bubble-free finish. That resin layer forms a physical shield against stone chips, brake dust, road salt, UV radiation, and the abrasive punishment of automatic car washes, keeping the logo crisp and vibrant season after season. The adhesive backing is a pressure-sensitive 3M-grade acrylic film. Peel the protective liner, center the emblem on a clean, dry cap surface, and press firmly for thirty seconds. The bond grabs on contact and reaches full strength within twenty-four hours — no drilling, no clips, no alignment tools. Diameters from 20 mm to 120 mm are in stock, fitting center caps across the full Vossen lineup including a set of HF-1s. Custom sizes are just a message away for anything non-standard.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.