Vossen Epoxy Sticker Superior Craft

Vossen Epoxy Sticker Superior Craft

• Materials Premium vinyl base topped with a 3D domed resin coating
• Diameter 20–120 mm (contact us for custom sizes)
• Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The Vossen HF-7 features a rotary-forged monoblock construction with a seven-spoke design that balances visual weight perfectly across the face. It is available in staggered fitments that allow wider rear setups on RWD and AWD platforms, and its flow-formed barrel delivers the strength-to-weight ratio that performance-oriented drivers demand. These 3D domed center cap emblems give your Vossen wheels the finishing detail they deserve. The construction starts with a high-resolution digital print of the Vossen logo on automotive-grade vinyl, reproducing the brand mark with pin-sharp accuracy. Over the print sits a thick dome of optically clear polyurethane resin, poured under controlled conditions and cured to a smooth, bubble-free finish. That resin layer forms a physical shield against stone chips, brake dust, road salt, UV radiation, and the abrasive punishment of automatic car washes, keeping the logo crisp and vibrant season after season. The adhesive backing is a pressure-sensitive 3M-grade acrylic film. Peel the protective liner, center the emblem on a clean, dry cap surface, and press firmly for thirty seconds. The bond grabs on contact and reaches full strength within twenty-four hours — no drilling, no clips, no alignment tools. Available in diameters from 20 mm through 120 mm, these emblems cover every cap variant across the Vossen range — from a set of HF-4s to the fully forged CV line. Non-standard sizes can be ordered.

How to Install (3 Easy Steps)

• PREP Clean the area thoroughly
• PEEL Remove the paper backing from the sticker
• STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.