Borbet Wheel Emblems Stylish Design

Materials Premium vinyl base topped with a 3D domed resin coating
Diameter 20–120 mm (contact us for custom sizes)
Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant

The Borbet name has been part of German manufacturing since Gustav Borbet opened a brass foundry in Altena back in 1881 — a heritage that spans nearly a century and a half. These 3D domed wheel center cap emblems bring that same German manufacturing quality down to the finest detail on your wheels. Each emblem is manufactured by printing the Borbet logo in full color at high resolution onto premium automotive-grade vinyl, using solvent-based inks specifically chosen for their long-term outdoor durability and resistance to fading. Over that printed surface, a thick, controlled pour of UV-stabilized polyurethane resin is applied and allowed to self-level into a perfectly smooth, bubble-free dome. The cured dome creates a glass-like surface with genuine three-dimensional depth that makes the logo appear to float beneath a clear lens. That resin layer does far more than look good — it resists scratches from stone chips and road grit, repels water, brake dust, and road salt, blocks ultraviolet radiation to prevent color fading, and remains flexible enough to survive thermal cycling from freezing winters to hot summer asphalt without cracking, peeling, yellowing, or lifting at the edges. The waterproof seal ensures no moisture can reach the printed layer underneath, keeping the emblem looking factory-fresh for years of daily driving and outdoor exposure. The adhesive backing is a pressure-sensitive acrylic film with a peel-away paper liner. Clean the cap surface with isopropyl alcohol, remove the liner, center the emblem, and press firmly for thirty seconds — no tools, no drilling, no heat gun required. The industrial-grade bond holds through highway speeds, automatic car washes, pressure washers, and seasonal temperature swings without any edge lift. Available in diameters from 20 mm through 120 mm, with custom sizes manufactured on request to match any cap recess. Price listed is for one emblem.

How to Install (3 Easy Steps)

PREP Clean the area thoroughly
PEEL Remove the paper backing from the sticker
STICK Carefully position the sticker and press firmly for at least 30 seconds

Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.

Shopping Cart

Borbet

Borbet Wheel Emblems Stylish Design

Filters

Categories

Brands

Borbet Wheel Emblems Stylish Design