Pontiac Emblem Wheel Center Caps Superior Craft
€3.30
Pontiac Epoxy Sticker Refined Design
€3.30

Pontiac Epoxy Sticker Elite Finish
Pontiac Epoxy Sticker Elite Finish
- Materials Premium vinyl base topped with a 3D domed resin coating
- Diameter 20–120 mm (contact us for custom sizes)
- Durability Features Scratch-resistant, waterproof, tear-resistant, and UV-resistant
- PREP Clean the area thoroughly
- PEEL Remove the paper backing from the sticker
- STICK Carefully position the sticker and press firmly for at least 30 seconds
Pontiac was discontinued by General Motors in 2010 as part of the restructuring that followed the 2008 financial crisis. The brand that had given America the GTO, the Trans Am, the Grand Am, and the Solstice was simply too close in market position to Chevrolet and Buick to survive GM's contraction. But the cars — and especially the center-cap arrowhead — endure in one of the most passionate enthusiast communities in the hobby. These 3D domed wheel center cap emblems carry that Pontiac arrowhead with the pride it deserves. The construction starts with a high-resolution digital print of the badge on automotive-grade vinyl, reproducing the iconic logo with pin-sharp accuracy. Over the print sits a thick dome of optically clear polyurethane resin, poured under controlled conditions and cured to a smooth, bubble-free finish. That resin layer forms a physical shield against stone chips, brake dust, road salt, UV radiation, and the abrasive punishment of automatic car washes, keeping the logo crisp and vibrant season after season. The adhesive backing is a pressure-sensitive 3M-grade acrylic film. Peel the protective liner, center the emblem on a clean, dry cap surface, and press firmly for thirty seconds. The bond grabs on contact and reaches full strength within twenty-four hours — no drilling, no clips, no alignment tools. Diameters from 20 mm to 120 mm are in stock, fitting caps across every Pontiac ever produced including a GTO. Custom sizes are just a message away for anything non-standard.
How to Install (3 Easy Steps)
Note: THESE STICKERS ARE INTENDED FOR FLAT SURFACES ONLY. THE PRICE IS FOR 1 EMBLEM.


